BOBO balloon installation tutorial

1. First, use the inflator or air tank to fill the wave balloon with gas, make it become a drum, and judge whether it is full according to the smoothness. When inflating, firmly hold the position of the inflating port with your hand to prevent it from running.

2, after filling the air to tie a tail knot, the knot must be tied tight, the balloon itself can not keep too long, if tied too loose is easier to run.

3. Put the LED light in the transparent pole of the balloon. During the wearing process, the wire should be straightened and not piled up in the transparent pole

4. Wrap the rest of the LED light string around the filled bobo balloon and make a circle from the top of the ball to the tail star "X"

5, install the battery, use the switch to open the light string, if the light is on, then the wave balloon is done, if not bright may be a bulb or battery problem, it can be replaced.